Center Zone Enable - Datalogic Magellan 1500i Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Center Zone Enable

Enables or Disables Center Zone Label Proofing. In "Always On" mode, Zone Proofing will be
applied to labels presented to the scanner while in Active State and in HandHeld State.
NOTE
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You'll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
DEFAULT
150301(CR)
Center Zone Proofing = On only when in ScannerActive-
Mode/ HandheldState
34
MAGELLAN™ 1500I
Labels rendered by segment assembly carry no coordinate data, and will not
be proofed if Center Zone Label Proofing is enabled.
150300(CR)
Center Zone Proofing = Disable
150302(CR)
Center Zone Proofing = Always on