Databar Limited 2D Component Enable - Datalogic Magellan 1500i Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

DataBar Limited 2D Component Enable

This feature controls if a 2D label component be decoded when a Databar Limited base
label is decoded.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
DEFAULT
035801(CR)
Databar Limited 2D Component = Enable
186
MAGELLAN™ 1500I
035800(CR)
Databar Limited 2D Component = Disable