EAN-13
EAN-13 First Character Transmission
Enables/disables transmission of EAN/JAN‐13 first character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
024401(CR)
EAN-13 First Character Transmission = Enable
PRODUCT REFERENCE GUIDE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
NOTE
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
barcode.
ENTER/EXIT PROGRAMMING MODE
024400(CR)
EAN-13 First Character Transmission = Disable
DEFAULT
141