Intercharacter Delay - Datalogic Magellan 1500i Product Reference Manual

RS-232 INTERFACE FEATURES
RS-232 Intercharacter Delay
Specifies delay between the end of one character and the beginning of the next in 10‐milli‐
second increments. This delay is inserted after each data character transmitted. If the trans‐
mission speed is too high, the system may not be able to receive all characters. You may
need to adjust the delay to make the system work properly.
To set the RS‐232 Intercharacter Delay:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode below,
3. Scan the appropriate digits from the
4. The scanner will automatically exit Programming Mode when the appropriate
DEFAULT
PRODUCT REFERENCE GUIDE
sent the desired delay. The selectable range is 0‐100, which is the delay in 10‐millisec‐
ond increments. Pad all single and double digit numbers with leading zeroes to yield a
three‐digit entry (000‐100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
amount of digits have been scanned.
Set RS-232 Intercharacter Delay
Alpha-Numeric Keypad in Appendix C
009C(CR)
Set RS-232 Intercharacter Delay
Default setting for this feature is:
00 - No Intercharacter Delay
ENTER/EXIT PROGRAMMING MODE
.
that repre‐
95