ENTER/EXIT PROGRAMMING MODE
PLANET CODE
Planet Code Enable
Enables/disables the ability of the scanner to decode Planet Code labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
DEFAULT
052201(CR)
Planet Code = Enable
284
MAGELLAN™ 1500I
052200(CR)
Planet Code = Disable