Label Id - Datalogic Magellan 1500i Product Reference Manual

5. Scan the END barcode once to finish the string, then scan END again to exit Program‐
ming Mode.
NOTE
6. The resulting message string would appear as follows:
Scanned barcode data:12345
Resulting message string output: $12345

LABEL ID

A Label ID is used to identify a barcode (symbology) type. It can be appended previous to or
following the transmitted barcode data depending upon how this option is enabled. This
feature provides options for configuring custom Label IDs individually per symbology. If you
wish to program the scanner to always include an industry standard label identifier for ALL
symbology types, see the feature,
The Label ID is a customizable code of up to three ASCII characters (each of which are hex
00‐7F) followed by a control character (00‐01), This control character, when set to zero,
does nothing. When set to one, it appends the symbology's AIM ID to the Label ID.
NOTE
Figure 13. Label ID Position
See
Label ID on page 111
, for a listing of common symbologies.
tings
If all 20 characters will be used in the prefix or suffix, do not scan the END
barcode to finish the string. It is done automatically.
When the control character is set to 01 for UPC-A and UPC-E, it expands
the label to EAN-13 and thus follows the EAN-13 Label ID settings.
Options
Prefix Label ID Aim ID
for programming barcodes. See
.
AIM ID on page 110
OR
Bar Code Data Label ID Suffix
Appendix D, Factory Default Set-
PRODUCT REFERENCE GUIDE
293