EAN-8
EAN-8/Jan-8 Both Guards Substitution
Enables/disables the ability of the scanner to find an EAN/JAN8 guard pattern in cases
where the EAN/JAN8 margin makes the guard look like a character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
DEFAULT
03CA01(CR)
EAN-8/JAN-8 Both Guards Substitution = Enable
PRODUCT REFERENCE GUIDE
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
barcode.
ENTER/EXIT PROGRAMMING MODE
03CA00(CR)
EAN-8/JAN-8 Both Guards Substitution = Disable
151