ENTER/EXIT PROGRAMMING MODE
Digital Watermark (Digimarc) Features
Digital Watermark (Digimarc) Enable
Enables/Disables the ability of the scanner to decode Digital Watermarks.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You'll need to cover any unused bar‐
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
049001(CR)
Digital Watermark (Digimarc) = Enable
28
MAGELLAN™ 1500I
The Digital Watermark feature must be enabled for decode functionality.
049000(CR)
Digital Watermark (Digimarc) = Disable
DEFAULT