Nak Character - Datalogic Magellan 1500i Product Reference Manual

ENTER/EXIT PROGRAMMING MODE
RS-232 NAK Character
This feature specifies which ASCII character will be used as a NAK character.
To specify the RS‐232 NAK Character:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode, SET RS‐232 NAK Character below. You'll need to cover any unused
barcodes on this and the facing page to ensure the scanner reads only the barcode
you intend to scan.
3. Scan the appropriate digits from the
sent the hex designation for the desired character. A table containing the ASCII Char‐
acter Set and their corresponding Hex Values is available in the inside back cover of
this manual. ASCII parameters must be input by scanning a pair of hexadecimal digits
for the desired character. For example, if ASCII "A" were the desired NAK character,
you would scan the digits "4", then "1" (the ASCII corresponding hex value).
4. The scanner will automatically exit Programming Mode when the appropriate
amount of digits/characters have been scanned.
DEFAULT
100
MAGELLAN™ 1500I
DO NOT set this feature to use previously defined characters
such as XON, XOFF or host commands as this will conflict with
normal operation of these characters. 8-bit data is not recog-
nized when the feature, RS-232 Number of Data Bits, is set to
NOTE
7 data bits.
Alpha-Numeric Keypad in Appendix C
0320(CR)
Set RS-232 NAK Character
Default setting for this feature is:
15
that repre‐