Eri Timeout - Datalogic Magellan 1500i Product Reference Manual

ERI Timeout

Specifies the amount of time the External Read Indicator (ERI) signal is held active for a
good read. Sets the ERI timeout duration using hex values from 000 to 255 in increments of
ten milliseconds (10ms or 0.01 seconds).
To configure this feature:
1. Scan the "Enter/Exit Programming Mode" barcode above to place the unit in Pro‐
gramming Mode.
2. Scan "Set ERI Timeout," followed by the two digits (zero padded) from the
Numeric Keypad in Appendix C
3. Exit programming mode by scanning the "Enter/Exit Programming Mode" barcode
again.
DEFAULT
PRODUCT REFERENCE GUIDE
ENTER/EXIT PROGRAMMING MODE
representing the desired time value.
00FA(CR)
Set ERI Timeout
Default setting for this feature is:
002 -20mS
Alpha-
43