CODE 39
Code 39 Check Character Transmission
Enables/disables transmission of optional Code 39 check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
008A01(CR)
Code 39 Check Character Transmission = Enable
PRODUCT REFERENCE GUIDE
This item is ignored when the advanced feature, Full Label Edit,
is enabled.
NOTE
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
Mode barcode.
ENTER/EXIT PROGRAMMING MODE
008A00(CR)
Code 39 Check Character Transmission = Disable
DEFAULT
199