Commissioning; Initial Commissioning; Selection Of The Measured Variable; Setting The Controller During Commissioning - ProMinent DULCOMETER Assembly And Operating Instructions Manual

5

Commissioning

Users' qualification: trained user, see
n
Ä Chapter 1.2 'Users' qualifications'
on page 7
WARNING!
Sensor run-in periods
This can result in hazardous incorrect
metering
– Correct measuring and metering
is only possible if the sensor is
working perfectly
– Please read the operating manual
for the sensor
– The sensor must be calibrated
after commissioning
Following completion of mechanical and
electrical assembly, the DULCOMETER
Compact Controller should be integrated
into the measuring point.
5.1

Initial commissioning

When first switching on the
DULCOMETER ® Compact Controller the
DULCOMETER Compact Controller is in
®
a STOP state.
Selection of the measurement variable,
controller setting and setting of the var‐
ious, process-dependent, parameters
Ä Chapter 7 'Operating
takes place next.
menus for the pH and redox measured
variables' on page 46 .
5.2 Selection of the measured
variable
The pH and redox measurement variables
are set in the
NOTICE!
Reset to factory settings
If you set or switch the measurement
variable, all parameters in the con‐
troller are reset to the factory settings
for the selected measurement vari‐
able.
You must then reset all the controller
functions.
5.3 Setting the controller during
commissioning
®
NOTICE!
Reset to factory settings
When switching over the metering
direction, all actuators in the
DULCOMETER
are reset to the factory settings for the
selected metering direction.
For safety reasons, all actuators are
deactivated. The base load is reset to
0 %. All parameters relating to the
actuator, are reset to the factory set‐
ting.
Consequently all parameters relating
to the actuator, must be reset.
Commissioning
'INPUT' menu.
Compact Controller
®
39