ABB Robotics FlexGripper Product Manual page 110

3 FlexGripper UI
3.3 Trouble shooting
Continued
Active view no valid test view
Description
Possible reason
Solution
Two many views
Description
Possible reason
Solution
Duplicated address
Description
Possible reason
Solution
Continues on next page
110
The current test view is not a valid test view.
Enter Control panel->Flexpendant-> AdditionalTestView, check if the
test view of the FlexGripper UI is selected.
When all the 6 places of the task bar are occupied by views, a warning
message box will pop up when clicking on the GUI icon.
Too many views are opened at the same time.
Close one or more of the views not in use.
Two I/O units with the same addresses are named with 'BOARD10'.
Enter Control panel->Configration-> Unit->BOARD10, edit the ad-
dresses name to BOARD11.
© Copyright 20132019 ABB. All rights reserved.
Product Manual - FlexGripper-Claw
4GAA40401009901-001 Revision: A