Setup - ABB Robotics FlexGripper Product Manual

3.2.4.2 Setup

Function
The production interface shows monitor signals on the left and monitor variables
on the right. The monitoring signals and variables shown can be set by the Setup
function.
Touch the Setup button, the interface with signal list shows.
After selecting one of the signals, using the two arrows buttons (see the picture
above) on the right to choose former signals or signals below.
Use the yellow double triangle/single triangle buttons to go to the first/last page or
to move the page up/down.
Product Manual - FlexGripper-Claw
4GAA40401009901-001 Revision: A
© Copyright 20132019 ABB. All rights reserved.
3 FlexGripper UI
3.2.4.2 Setup
Continues on next page
105