Table of Contents
Advertisement
NetVanta 1335 Series Hardware Installation Guide
Power over Ethernet
The NetVanta 1335 Series PoE devices provide the same basic functionality as the other NetVanta 1335 Series
products. PoE provides the ability to detect attached powered devices (PDs), and deliver 48 VDC to the PD via
existing cabling. The PoE devices are fully compliant with the IEEE 802.3af PoE standard. By default, the PoE
switches discover and provide power to IEEE-compliant PDs.
NetVanta 1335 Shipping Contents
Each NetVanta 1335 unit is shipped in its own cardboard shipping carton. Open each carton carefully, and avoid
deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in transit,
immediately file a claim with the carrier and contact ADTRAN Customer Service (refer to the Repair and
Replacement section of the Support page on the ADTRAN website at http://www.adtran.com/support).
Domestic shipments of the NetVanta 1335 include the following items:
•
NetVanta 1335 base unit
•
Quick start guide
•
A detachable power cable with a grounded, three-prong plug
International shipments of the NetVanta 1335 include the following items:
•
NetVanta 1335 base unit
•
Quick start guide
•
All necessary power cords
NetVanta 1335 Series Front Panel Design
The NetVanta 1335 Series front panels are shown in
18
describes all of the LEDs, and
NetVanta 1335 Front Panel Features
10/100Base-T Ethernet Interfaces
The NetVanta 1335 Series units contain 24 10/100Base-T Ethernet interfaces (RJ-45). These interfaces
are consecutively numbered 1 through 24, from left to right, with the numbers screened directly above
each port. Status LEDs for each of these interfaces are located directly over these numbers.
Gigabit Ethernet Interfaces/SFP Slots
The NetVanta 1335 and NetVanta 1335 PoE contain two Gigabit Ethernet interfaces that provide two
fixed RJ-45 connectors and two standard SFP slots for fiber connectivity. These interfaces are labeled
and
and the status LEDs are located above the SFP slots.
G1
G2,
Status LEDs
The status LEDs are located to the lower left of RJ-45 port 1. The
installed NIM. The
DBU
The
LED indicates the unit's status.
STAT
61700515E2-34C
Figure 1
Appendix A on page 53
LED reflects the status of an installed dial backup interface module (DIM).
Copyright © 2011 ADTRAN, Inc.
below and
Figure 2 on page
shows the connector pinouts.
WAN
LED reflects the status of an
Physical Description
18.
Table 1 on page
17
Advertisement
Table of Contents
