Powering On The At-Pwr250-80 Dc Power Supply; Figure 60: On/Off Switch On The At-Pwr250-80 Dc Power Supply - Allied Telesis AT-x930-28GTX Installation Manual

Chapter 9: Powering On the Switch

Powering On the AT-PWR250-80 DC Power Supply

120
This section contains the procedure for powering on the AT-PWR250-80
DC Power Supply. Please review the following items before powering on
the device:
 This procedure assumes you have already wired the DC connector
on the AT-PWR250-80 DC Power Supply. For instructions, refer to
Chapter 8, "Wiring the DC Connector on the AT-PWR250-80
Power Supply" on page 111.
 If the switch has two power supplies, you may power them on at
the same time or individually.

Refer to "Power Specifications" on page 153 for the power
specifications of the switches.
To power on the AT-PWR250-80 Power Supply, perform the following
procedure:
1. Power on the DC circuit to which the power supply is connected.
2. Set the On/Off switch on the power supply to On. Refer to Figure 60.
Figure 60. On/Off Switch on the AT-PWR250-80 DC Power Supply
On/Off Switch