Powering On The Pwr300 Power Supply; Figure 54: Connecting The Pwr300 Power Supply To The X320-10Gh Switch - Allied Telesis x320 Series Installation Manual

Powering on the
PWR300 Power
Supply
3. Connect the other end of the external harness to the PWR300 power
supply. Refer to Figure 54.
Figure 54. Connecting the PWR300 Power Supply to the x320-10GH
4. Repeat this procedure to connect the switch to additional PWR300
power supplies.
Before powering on the switch, review the information in "Power
Specifications" on page 119 for the power specifications of the switches.
Warning
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.  E3
Note
Pluggable Equipment. The socket outlet shall be installed near the
equipment and shall be easily accessible.  E5
To power on the switch, perform the following procedure:
1. Install the power cord retaining clip on the AC power connector on the
front panel of the PWR300 power supply. Refer to Figure 55 on page
97.
x320 Series Installation Guide
Switch
96