Comtech EF Data LPOD Series Installation And Operation Manual page 142

Controller-to-Target
Parameter
Instruction Code and
Type
Qualifier
(* indicates
End-of-Life)
Command Query
Management IP IPA= IPA?
Address
Gateway IP IPG= IPG?
Address
Initialize ISP= N/A
Statistics
Pointer
Serial Interface Operation
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
18 bytes Command or Query.
Sets or returns the Management IP Address and network prefix for the 'J6 |
COM1' 10/100 BaseT Ethernet management port, in the form xxx.xxx.xxx.xxx.yy,
where:
xxx.xxx.xxx.xxx=the IP Address
yy=the network prefix (8 to 30)
Default value: 192.168.001.004.24
COMMAND EXAMPLE: <0001/IPA=192.168.001.004.24{CR}
CAUTION: Changing the Management IP Address through the Telnet interface
requires you to power cycle the unit, and then restart a new Telnet session with
the new IP Address. The IP Address that you type into the Telnet client software
does not include the range parameter so it would be: 192.168.1.4
15 bytes Command or Query.
Sets or returns the Gateway IP address for the 10/100 Base Tx Ethernet
management port, in the form xxx.xxx.xxx.xxx.
Default value: 192.168.001.005
COMMAND EXAMPLE: <0001/IPG=192.168.001.005{CR}
None Command only.
Resets the internal pointer to allow RNS? queries to start at the beginning of the
stored statistics log. This command takes no arguments.
EXAMPLE: <0001/ISP={CR}
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Description of Arguments
5–22
Revision 15
Target-to-Controller
(see Description of
Arguments)
Response to Response
Command to Query
IPA= IPA=xx.xxx
.xxx.xxx.yy
IPA?
IPA*
IPA#
IPG= IPG=xxx.xx
x.xxx.xxx
IPG?
IPG*
ISP= N/A
ISP?
ISP*
MN-LPOD