Config | Utility - Comtech EF Data LPOD Series Installation And Operation Manual

4.5.3.3

Config | Utility

Use this page to configure additional LPOD operating parameters.
Utility
Click [Refresh] to see the latest page data.
Name
Date (MM/DD/YY)
Time (HH:MM:SS)
Circuit ID
Current Ative Firmware Image
Next Reboot Image
Perform Soft Reboot
Ethernet Interface Operation
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Figure 4-13. 'Config | Utility' Page
Enter a date using international format in the form DD/MM/YY (where
DD = day [01 to 31], MM = month [01 to 12], and YY = year [00 to 99]).
Click [Change Date/Time] to save the changes.
Enter a time using HH:MM:SS format (where HH = hour [00 to 23],
MM = minutes [00 to 59], and SS = seconds [00 to 59]).
Click [Change Date/Time] to save the changes.
Enter a Circuit ID (unit identification label) string of up to 48 characters. This is
the identification label for the unit.
Click [Change CID] to save the change.
This read-only window shows the Current Active Firmware Image. In this
example, Image 1 is the Current Active Firmware Image.
Use the drop-down list to select the Next Reboot Image as Image 1 or 2.
Click [Submit] to save the change.
Click [Reboot Now] to reboot the LPOD using the Current Active Firmware
Image.
4–23
Description
Revision 15
MN-LPOD