Table of Contents
Advertisement
Appendix A. 1:1 REDUNDANCY
A.1
LPOD Redundancy Operation Overview
Chapter 2. SYSTEM CONNECTORS, INSTALLATION
The LPOD Outdoor Amplifier / Block Up Converter can configured for 1:1 redundancy by
connecting the appropriate 1:1 Redundancy Cable to the 'J6 | COM1' connector (see Chapter 2.
SYSTEM CONNECTORS, INSTALLATION
Once you set up a 1:1 Redundancy System, use the proper serial remote commands or HTTP
Interface page controls to place the units into Redundancy Mode. The system automatically
configures the backup (offline) unit by copying the configuration from the active (online) unit.
Appendix A
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
STARTUP).
AND
A–1
Revision 15
STARTUP
AND
MN-LPOD
Advertisement
Table of Contents
Need help?
Do you have a question about the LPOD Series and is the answer not in the manual?
Questions and answers