Comtech EF Data LPOD Series Installation And Operation Manual page 139

Controller-to-Target
Parameter
Instruction Code and
Type
Qualifier
(* indicates
End-of-Life)
Command Query
Set RTC Date DAY= DAY?
(by Day)
Enable ESA= ESA?
Statistics
Averaging
Enable ESL= ESL?
Statistics
Logging
Enable ESW= ESW?
Redundancy
Switch Mode
Serial Interface Operation
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
6 bytes Command or Query.
Sets or returns the Reasl-Time-Clock date in the form ddmmyy, where:
dd=day of the month (01 to 31)
mm=month of the year (01 to 12)
yy=year (00 to 99) (2000 to 2099)
COMMAND EXAMPLE (date=April 25, 2016): <0001/DAY=250416{CR}
1 byte Command or Query.
Enables or Disables averaging of statistics data, at a rate of once per second
every 10 seconds, in the form x, where:
0=Disable (DEFAULT – SEE NOTE)
1=Enable
NOTE: If Disabled, burst values will be logged instead of averaged values.
COMMAND EXAMPLE: <0001/ESA=0{CR}
1 byte Command or Query.
Sets or returns the statistics logging function in the form x, where:
0=Disable (DEFAULT)
1=Enable
COMMAND EXAMPLE: <0001/ESL=1{CR}
1 byte Command or Query.
Sets or returns the redundancy state in the form x, where:
0=Off (DEFAULT)
1=1:1 Redundancy Tx (Only Tx switch installed)
2=1:1 Redundancy Tx + RX (Tx and RX switch installed)
5=1:1 Manual redundancy mode (used for debugging, or redundancy system
setup) (SEE NOTE)
NOTE: Manual redundancy does not support automatic switching, and the offline
unit will not poll the online unit to update its configuration.
COMMAND EXAMPLE: <0001/ESW=1{CR}
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Description of Arguments
5–19
Revision 15
Target-to-Controller
(see Description of
Arguments)
Response to Response
Command to Query
DAY= DAY=ddm
myy
DAY?
DAY*
ESA= ESA=x
ESA?
ESA*
ESL= ESL=x
ESL?
ESL*
ESW= ESW=x
ESW?
ESW *
MN-LPOD