Table of Contents
Advertisement
Controller-to-Target
Parameter
Instruction Code and
Type
Qualifier
(* indicates
End-of-Life)
Command
Query
Global Amplifier
Configuration
(Cont)
Initialize Events
IEP=
N/A
Pointer
Software Image IMG=
IMG?
Serial Interface Operation
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
fffff=Unit Alarm Mask (MSK)
g=LNB Current Source (LCS)
hh=LNB Current Window (LCW)
i=LNB Current Window Enable (CWE)
j=Enable Statistics Averaging (ESA)
k=Set Statistics Interval (SSI)
l=Enable Statistics Logging (ESL)
m=Auxiliary Mute (AUX)
n=user mute state (MUT)
o=RF power amplifier state (AMP)
COMMAND EXAMPLE: <0001/GAC=a;b;cc.cc;dd.dd;e;fffff;g;hh;I;j;k;l;m;n;o;{CR}
None
Command only.
Resets internal pointer to allow RNE? queries to start at the beginning of the
stored events log. This command takes no arguments.
EXAMPLE: <0001/IEP={CR}
1 byte
Command or Query.
Sets or returns the Current Active Software Image in the form x, where:
1=Bulk Image # 1 currently active
2=Bulk Image # 2 currently active
COMMAND EXAMPLE: <0001/IMG=1{CR} (instructs the unit to load firmware
from image #1 at the next reset / power up).
QUERY EXAMPLE: <0001/IMG?{CR} (queries the image number that the
firmware loaded during bootup)
NOTE: If you send the IMG command and then query the IMG value, the numbers
may not be equal because the command tells the firmware which image to boot from
at the next bootup, while the query reports the image that the firmware booted from
on the previous bootup.
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Description of Arguments
5–21
Revision 15
Target-to-Controller
(see Description of
Arguments)
Response to
Response
Command
to Query
IEP=
N/A
IEP?
IEP*
IMG=
IMG=x
IMG?
IMG*
IMG#
MN-LPOD
Advertisement
Table of Contents
