Lpod Unit Firmware Updates - Comtech EF Data LPOD Series Installation And Operation Manual

3.4.4 LPOD Unit Firmware Updates

Chapter 4. ETHERNET INTERFACE OPERATION
Use the LPOD HTTP Interface to select the new firmware and soft-reboot the unit. Go to the
'Config | Utility' page and do these steps:
1. Select the preferred Current Active Firmware Image:
a. Use the 'Next Reboot Image' drop-down list to select Image 1 or 2.
b. Click [Submit].
2. Soft-reboot the LPOD:
a. In the 'Perform Soft Reboot' section, click [Reboot Now].
b. Wait while the LPOD reboots with the Current Active Firmware Image.
3. To load a second image, repeat Steps 1 and 2.
4. After the unit has rebooted with the new firmware, you must clear the trending data. Use
the terminal emulator or CLC-10 Handheld Terminal to enter serial remote command
"<0/CTD=1{CR}", which will cear the trendind data.
The LPOD is now operating with its latest firmware. The firmware update process is complete.
Firmware Update
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
3–14
Revision 15
MN-LPOD