Comtech EF Data LPOD Series Installation And Operation Manual page 103

Amplifier
Name
Attenuation (dB)
Attenuation Offset
Fault Recovery
Mute
Aux Mute
Offline Mute
Click [Reset] to restore the previously saved settings.
Click [Change Configuration] to save any changes.
Reference
Name
Ref Freq Adjust
Ext Ref Mute
Click [Reset] to restore the previously saved settings.
Click [Change Configuration] to save any changes.
Low Power Forward Threshold (dBm)
When the forward power monitor is set to Alarm or Fault instead of the factory default of Mask,
and the forward power drops below the specified value, the alarm/fault occurs.
Set the threshold value, in dBm, for the low forward power alarm/fault.
To disable the threshold, set this parameter to the default value of 00.00.
Click [Change] to save any changes.
FSK Address
Set the FSK (Frequency Shift Keying) Address from 01 to 15.
Click [Change] to save any changes.
Ethernet Interface Operation
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Enter a valid attenuation level (00.00 to 20.00 dB) in 0.25 dB steps.
Enter a valid offset value, in dB.
Use the drop-down list to select Automatic or Manual.
Use the drop-down list to select Enabled or Disabled.
Use the drop-down list to select Enabled or Disabled.
Use the drop-down list to select Enabled, Disabled, MuteRx, MuteTx,
MuteRx+LNB, MuteTx+LNB, Mute Tx+Amp, or Mute Tx+LNB+Amp.
Enter a valid reference oscillator tuning voltage value from 0 to 255. The
default value is set to 87.
Use the drop-down list to select the External Reference Not Present Mute
Mode as either Enabled or Disabled.
4–21
Description
Description
Revision 15
MN-LPOD