Comtech EF Data LPOD Series Installation And Operation Manual page 160

Controller-to-Target
Parameter
Instruction Code and
Type
Qualifier
(* indicates
End-of-Life)
Command Query
SNMP Write SWC= SWC?
Community
Software N/A SWR?
Revision
Set RTC Time TIM= TIM?
Temperature N/A TMP?
Retrieve N/A TNA?
Number of
Unread Stored
Alarms*
Serial Interface Operation
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
16 bytes, Command or Query.
characters, no Sets or returns the SNMP Write Community string.
spaces
COMMAND EXAMPLE: <0001/SWC=private{CR}
NOTE: An empty string is not allowed.
34-37 bytes Query only.
Returns the value of the internal software revision installed in the unit, in the form:
Boot:x.y.z Bulk1:x.y.z Bulk2:x.y.z
-or-
Boot:x.y.zz Bulk1:x.y.zz Bulk2:x.y.zz
6 bytes Command or Query.
Sets or returns the Real-Time-Clock time in the form hhmmss, where:
hh=hours, from 00 to 23;
mm=minutes, from 00 to 59,
ss=seconds, from 00 to 59
COMMAND EXAMPLE (time=23 hours, 12 minutes and 59 seconds since
midnight – i.e., 11:12:59 PM):
<0001/TIM=231259{CR}
5 bytes Query only.
Returns the temperature of the Heatsink in the form sxxxx, where:
s=sign byte, positive or negative (+ or –)
xxxx=temperature (including decimal point)
EXAMPLE: <0001/TMP?{CR}
<0001/TMP=+26.0{CR}{LF}
2 bytes Query only.
Returns the number of stored events that remain unread in the alarm log in the
form xx, where:
xx=number from 00 to 99.
NOTE: Although a maximum of 255 events may be stored in the alarm log, event
tallies greater than 99 are reported as 99.
EXAMPLE: <0001/TNA?{CR}
>0001/TNA=14{CR}{LF}
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Description of Arguments
5–40
Revision 15
Target-to-Controller
(see Description of
Arguments)
Response to Response
Command to Query
SWC = SWC=x
SWC!
SWR= SWR=Boot
:x.y.zz
Bulk1:x.y.z
z
Bulk2:x.y.z
TIM = TIM=xxxxx
x
TIM?
TIM *
TMP= TMP=sxxx
x
TNA= TNA=xx
MN-LPOD