Comtech EF Data LPOD Series Installation And Operation Manual page 158

Controller-to-Target
Parameter
Instruction Code and
Type
Qualifier
(* indicates
End-of-Life)
Command Query
SNMP Enable SNM= SNM?
Serial Number N/A SNO?
Set Physical SPA= SPA?
remote Address
SNMP Read SRC= SRC?
Community
SNMP System SSC= SSC?
Contact
Set Statistics SSI= SSI?
Interval
Serial Interface Operation
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
1 byte Command or Query.
Sets or returns SNMP in the form x, where:
0=Disabled
1=Enabled
COMMAND EXAMPLE: <0001/SNM=0{CR}
9 bytes Query only.
Returns the unit's nine-digit serial number in the form xxxxxxxxx.
NOTE: This query is functionally identical to RSN.
EXAMPLE: <0001/SNO?{CR}
>0001/SNO=012345678{CR}{LF}
4 bytes Command or Query.
Sets or returns the Physical Address in the form xxxx where:
xxxx=Address value from 0001 (DEFAULT) to 9999.
COMMAND EXAMPLE: <0001/SPA=0412{CR}
16 bytes, Command or Query.
characters, no Sets or returns the SNMP Read Community string.
NOTE: An empty string is not allowed.
spaces
COMMAND EXAMPLE: <0001/SRC=public{CR}
255 bytes, Command or Query.
characters Sets or returns the SNMP System Contact string.
COMMAND EXAMPLE: <0001/SSC=Joe Net Admin{CR}
NOTE: When not configured, the target returns an empty string:
<0001/SSC={CR}{LF}
2 bytes Command or Query.
Sets or returns the time interval, in minutes, at which statistics are logged in the
form xx, where:
xx=interval, from 01 to 99 minutes (SEE NOTE)
Default value: 90 minutes.
COMMAND EXAMPLE: <0001/SSI=90{CR}
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Description of Arguments
5–38
Revision 15
Target-to-Controller
(see Description of
Arguments)
Response to Response
Command to Query
SNM= SNM=x
SNM?
SNO= SNO=xxxxx
xxxx
SPA= SPA=xxxx
SPA?
SPA*
SRC = SRC=x
SRC!
SSC = SSC=x
[1..128]
SSC!
SSI= SSI=xx
SSI?
MN-LPOD