Creflash" Utility Upload (Optional) - Comtech EF Data LPOD Series Installation And Operation Manual

3.4.3 "CReflash" Utility Upload (Optional)

The "CReflash" utility is available on request from CEFD Product Support.
To upload the "CReflash" firmware files, do these steps:
1. Obtain the CReflash utility (CReflash.exe) from CEFD. Place the application into the
temporary folder that you created for the firmware update process (or some other easy-
to-remember location, e.g., the Windows Desktop).
2. From the temporary folder – Locate, and then double-click, the "CReflash.exe" filename
or icon. The CReflash utility opens:
3. Enter your upload parameters information into CReflash:
a. Left-click in the "IP Address:" text box, and enter the default Management IP
b. Left-click in the "Local Filename:" text box. Then, click [Browse] and navigate to
c. Make sure the drop-down list remains set to "bulk:".
d. Click [Start] to begin the upload process. If the information was correctly entered
4. When done, click [Cancel] to exit CReflash.
Firmware Update
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Address (e.g., 192.168.1.4).
the temporary folder created earlier. Click on the firmware "BIN" filename, and
then click [Open]. The filename will appear in the "Local Filename:" text box.
into CReflash, the utility displays an animated progress bar at the bottom of the
window, along with a series of messages:
•
"Opening FTP"
•
"Sending data file to modem:"
•
"Writing FLASH: # of #"
•
"Success!"
3–13
Revision 15
MN-LPOD