Configure Hyperterminal For Telnet Remote Control Operation; Figure 4-3. Configure Hyperterminal - Comtech EF Data LPOD Series Installation And Operation Manual

4.3.1.1

Configure HyperTerminal for Telnet Remote Control Operation

Do the following steps (See Figure 4-3):
1. Define the Connect To Telnet connection properties correctly (File  Properties) (Figure
4-3, left side):
a. Enter the LPOD's Traffic/Management IP Address as the "Host address" (e.g.,
b. Enter TCP Port 23 as the "Port number".
c. Set "Connect using" to TCP/IP (Winsock) instead of COM1 or COM2.
d. Click [OK] to save your settings.
2. ASCII Setup (File  Properties  Settings  ASCII Setup) (Figure 4-3, right side):
a. Check the "Send line ends with line feeds" option in the 'ASCII Sending' section.
b. Check the "Append line feeds to incoming line ends" option in the 'ASCII
c. Click [OK] to save your settings.
Ethernet Interface Operation
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
192.168.1.1).
Receiving' section.

Figure 4-3. Configure HyperTerminal

4–8
Revision 15
MN-LPOD