Connector 'J9 | Output Sample' (Ps 2 Only); Connectors 'J10 | Modem Rx' And 'J11 | Lnb' (Optional Interfaces); Ground Connector; Figure 2-6. 'J10 | Modem Rx' And 'J11 | Lnb' Connectors - Comtech EF Data LPOD Series Installation And Operation Manual

2.3.6 Connector 'J9 | OUTPUT SAMPLE' (PS 2 Only)

2.3.7 Connectors 'J10 | MODEM Rx' and 'J11 | LNB' (Optional Interfaces)

The 'J10 | MODEM Rx' and 'J11 | LNB' ports are both Type 'N' female connectors, providing
both bias and a reference signal to an LNB, and passing the LNB's L-Band output to the modem's
Rx input.

2.3.8 Ground Connector

Use this #10-32 stud, available where shown in Figure 2-7, to connect a common
chassis ground among equipment.
System Connectors, Installation, and Startup
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
The 'J9 | OUTPUT SAMPLE' port is a Type 'N' female connector
available only on the PS 2 model. It provides a nominal -40 dB sample of
the output signal. A calibration label is provided near the connector that
shows the actual coupling values vs. frequency.

Figure 2-6. 'J10 | Modem Rx' and 'J11 | LNB' Connectors

Figure 2-7. Ground Connector Locations

2–13
Revision 15
MN-LPOD