Comtech EF Data LPOD Series Installation And Operation Manual page 159

Controller-to-Target
Parameter
Instruction Code and
Type
Qualifier
(* indicates
End-of-Life)
Command Query
SNMP System SSL= SSL?
Location
SNMP Unit SSN= SSN?
Name
SNMP Trap STA= STA?
Destination IP
Address 1
SNMP Trap STB= STB?
Destination IP
Address 2
SNMP Trap STV= STV?
Version
Serial Interface Operation
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
255 bytes, Command or Query.
characters Sets or returns the SNMP System Location string.
COMMAND EXAMPLE: <0001/SSL=Upstairs back right.
NOTE: When not configured, the target returns an empty string.
<0001/SSL={CR}{LF}
16 bytes, Command or Query.
characters Sets or returns the SNMP Unit Name string.
COMMAND EXAMPLE: <0001/SSN=Remote1{CR}
NOTE: When not configured, the target returns an empty string.
<0001/SSC={CR}{LF}
15 bytes, Command or Query.
Numerical Sets or returns the IP Address of the SNMP Trap Destination IP Address 1 (where
traps will be sent first) in the form xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx=IP Address
COMMAND EXAMPLE: <0001/STA=010.006.030.001{CR}
NOTE: When not configured, the target returns >0001/STA=0.0.0.0{CR}{LF}
15 bytes, Command or Query.
Numerical Sets or returns the IP Address of the SNMP Trap Destination IP Address 2 in the
form xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx=IP Address
COMMAND EXAMPLE: <0001/STB=010.006.030.002{CR}
NOTE: When not configured, the Target returns >0001/STB=0.0.0.0{CR}{LF}
1 byte Command or Query.
Sets or returns the SNMP Trap Version that will be used to send traps in the form
x, where:
1=SNMP Trap Version 1
2=SNMP Trap Version 2
COMMAND EXAMPLE: <0001/STV=0{CR}
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Description of Arguments
5–39
Revision 15
Target-to-Controller
(see Description of
Arguments)
Response to Response
Command to Query
SSL = SSL=x[1..1
28]
SSL!
SSN = SSN=x[1..1
28]
SSN!
STA = STA=xxx.x
xx.xxx.xxx
STA!
STB = STB=xxx.x
xx.xxx.xxx
STB!
STV = STV=x
STV!
MN-LPOD