Assigning Perforation Cutting - GRAPHTEC FC4500 User Manual

Chapter 5 FUNCTION SETTINGS AND OPERATIONS

5.10 Assigning Perforation Cutting

This function allows you to assign the perforation cutting operation to COND Nos. 1 to 8.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the [NEXT] key repeatedly until the following menu is displayed.
FORCE
I/F
TOOL COND AREA OPT
SPEED
(3) Press the [F2] key (TOOL COND) to display the menu shown below.
FORCE
THICK
TOOL No. ADJ.T POS
SPEED
(4) Press the [F3] key (CUT LINE) to display the perforation cutting operation assignment setting screen.
FORCE
COND. No. 12345678
CUT LINE
SPEED
Blinking cursor
The upper row of the display represents the cutting condition COND Nos. A check mark [ ] is displayed for any of
the COND. Nos. to which the perforation cutting operation has been assigned.
Use the [ ] or [
cutting operation to, and the [
Press the [ENTER] key to confirm your selections.
(5) Press the [PAUSE] key to cancel PAUSE mode.
•
These settings are retained in the plotter's internal memory even while the plotter is turned off.
•
Please see Section 3.7, "Setting the Cutting Conditions" for details on perforation settings.
5-12
OFFSET
FUNCTION
QUALITY
OFFSET
CUT LINE
QUALITY
OFFSET
QUALITY
] key to move the blinking cursor to the COND. No. that you want to assign the perforation
] or [ ] key to display or hide the check mark [ ].