Table of Contents
Advertisement
(7) Press the [F4] key (LEVEL) to display the menu shown below.
FORCE
SENSITIVITY ADJUST
•DEFAULT
SPEED
To select the default value, press the [F2] key (DEFAULT) and then press the
To set the sensitivity of the sensor, press the [F4] key (USER) and then press the
(8) If the [F4] key (USER) was pressed, the sensor judgment value screen is displayed.
FORCE
VALUE
SENSITIVITY
SPEED
(9) Press the [F4] key (SENSITIVITY) to display the menu for adjusting the sensitivity of the sensor.
FORCE
SENSITIVITY
DEFAULT
SPEED
(10) To adjust the sensitivity value, press the [F4] key (ADJUST) to display the following prompt. To select the default
value, press the [F2] key (DEFAULT).
FORCE
MOVE TO ADJ. POINT
PRESS ENTER KEY!
SPEED
(11) Use the [
] [
] [
blank area of the medium (an area where there is no drawing) and then press the
shown at the left is displayed during the adjustment process, and the prompt shown at the right is displayed when
adjustment has been completed.
FORCE
SENSOR ADJUST
PLEASE WAIT
SPEED
OFFSET
USER
QUALITY
OFFSET
AUTO
QUALITY
OFFSET
ADJUST
QUALITY
OFFSET
QUALITY
] [
] keys to move the tool carriage (the tip of the tool selected by the current setting) to a
OFFSET
QUALITY
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
FORCE
SENSOR ADJUST
COMPLETED
SPEED
[ENTER] key.
[ENTER] key.
[ENTER] key. The prompt
OFFSET
QUALITY
4-19
Advertisement
Table of Contents
