Table of Contents
Advertisement
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
Selectable parameters: MODE 1. MODE 2, MODE 3
Actual Data
Modes 2 and 3 enable thick media to be bent easily.
Setting the Spacing
(4) Press the [F2] key to move the blinking cursor to the position shown in the following screen.
FORCE
MODE2
SPC 1.00mm STR0.00mm
SPEED
The spacing parameter is only enabled for Modes 2 and 3. The blinking cursor does not move when Mode 1 has
been selected.
(5) Use the [
] or [
Setting range: 0.01 to 9.99 mm
Mode 2 (Crease two lines)
Actual data
(creasing is not performed
at the actual data position)
Setting the Number of Creasing Operations
(6) Press the [F3] key to move the blinking cursor to the position shown in the following screen.
FORCE
MODE2
SPC 1.00mm STR0.00mm
SPEED
(7) This setting determines how many times creasing should be repeated for each line segment. Use the [
key to select the value. Increase the number if the crease is faint after one creasing operation.
Setting range: 1 to 9 (times)
Setting the Start and End Positions
(8) Press the [F4] key to move the blinking cursor to the position shown in the following screen.
FORCE
MODE2
SPC 1.00mm STR0.00mm
SPEED
3-16
Mode 1 (Crease one line)
Crease lines at the same position
as the actual data.
OFFSET
COUNT1
QUALITY
] key to move the position of the blinking cursor, and the [
Mode 3 (Crease three lines)
Spacing
Actual data
OFFSET
COUNT1
QUALITY
OFFSET
COUNT1
QUALITY
Mode 2 (Crease two lines)
Crease lines at positions on either side
of the actual data. (Creasing is not
performed at the actual data position)
Spacing
Mode 3 (Crease three lines)
Actual data
Crease lines at the same position
as and on either side of the actual
data.
] or [
] key to select the value.
Actual data
] or [
]
Advertisement
Table of Contents
