Table of Contents
Advertisement
If the value you input is exceedingly large (1.5 times or greater) or very small (0.5 times or less), or if the angle of tilt
with respect to the original axis tilt is 45° or greater, the following prompt is displayed. In this case, please re-input
the value.
FORCE
DISTANCE ADJUSTMENT
ERROR. SET AGAIN!
SPEED
(5) If 3-point or 4-point adjustment has been selected, the menu for adjusting the distance between points 1 and 3 will
be displayed. Make the settings in the same way as for the distance between points 1 and 2.
(6) When the distances between all the points have been adjusted, the following menu for setting the axis adjustment
origin is displayed. (This menu is not displayed when 4-point reading has been selected.)
FORCE
AXIS ORIGIN POINT
X=
0
SPEED
Use the [
] [
] [
to the position for setting the axis adjustment origin, and then press the
been performed previously, the tool carriage will move automatically to the previously set reference point. In this
case, use the [
] [
(7) When all the adjustments have been completed, the plotter returns to Ready status.
OFFSET
QUALITY
OFFSET
Y=
0
QUALITY
] [
] keys to move the tool carriage (the tip of the tool or pen selected by the current setting)
] [
] [
] keys to make any adjustments required.
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
[ENTER] key. If 2-axis adjustment has
4-25
Advertisement
Table of Contents
