Table of Contents
Advertisement
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(4) Press the
[ENTER] key to display the screen for setting the Perforation Mode values.
FORCE
C LINE PAT.
C=00.00mm
SPEED
(5) "C" represents the cut length, "U" represents the uncut length, and "UP" represents the force when the tool is in the
tool-up status. Use the [
the [
] or [
[C, U] setting range: 0 to 99.99 (mm)
[UP] Setting range: 0 to 48 (0 raises the tool)
(6) When the displayed settings are correct, press the
key.
3-20
OFFSET
UP=10
U=00.00mm
QUALITY
] or [
] key to move the blinking cursor to the parameter that you wish to change, and
] key to change the value.
[ENTER] key. To cancel your settings, press the
[NEXT]
Advertisement
Table of Contents
