Table of Contents
Advertisement
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
When the data includes registration mark commands
(1) Send the data that you wish to copy to the plotter and then perform a cutting operation to enable the data to be
stored in the plotter's buffer.
(2) Set the COPY origin. Use the [
the current setting) to the desired starting position for cutting copies.
(3) Press the
[COPY] key to select COPY mode. The following screen for setting the number of copies appears.
FORCE
COPY MODE
COUNT
SPEED
(4) Use the [
] or [
higher than the maximum number of copies that can be cut out of the currently loaded medium.
(5) Press the
[ENTER] key to start making copies.
(6) The following message is displayed after one copy has been made.
FORCE
MOVE TO ADJ. POINT
PRESS ENTER KEY!
SPEED
(7) If you wish to make another copy, press the
When the data includes registration mark commands
(1) Send the data that you wish to copy to the plotter and then perform a cutting operation to enable the data to be
stored in the plotter's buffer.
(2) Press the
[COPY] key to select COPY mode. The following screen appears.
FORCE
MOVE TO ADJ. POINT
PRESS ENTER KEY!
SPEED
(3) Set the COPY origin. Use the [
the current setting) to the desired starting position for cutting copies.
(4) Press the
[ENTER] key if you wish to make a copy.
3-28
] [
] [
] [
OFFSET
1
QUALITY
] key to set the desired number of copies to be made. Be sure to set the number of copies no
OFFSET
QUALITY
OFFSET
QUALITY
] [
] [
] [
(but excluding multiple registration marks)
] keys to move the tool carriage (the tip of the tool/pen selected by
[ENTER] key.
(including multiple registration marks)
] keys to move the tool carriage (the tip of the tool/pen selected by
Advertisement
Table of Contents
