Table of Contents
Advertisement
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
•
Setting the VIEW beeper/time until VIEW (BEEPER VIEW/VIEW TIME)
[Default settings: 60 min/30 sec]
BEEPER VIEW: This parameter enables command specification of the length of time that the beeper sounds while
VIEW TIME:
Use the [F3] and [F4] keys to move the blinking cursor (
5-36
the plotter is in the VIEW status. The selections are OFF, 1, 5, 10, 30, and 60 (min).
This parameter sets the length of time between the Ready status and the VIEW status. The
selections are OFF, 10, 20, 30 and 60 (sec).
).
Advertisement
Table of Contents
