GRAPHTEC FC4500 User Manual page 70

Hide thumbs Also See for FC4500:
Table of Contents

Advertisement

Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
(4) Press the [F1] key (MARK) to display the registration mark functions selection menu.
FORCE
MODE
TYPE
SPEED
(5) Press the [F4] key (OTHER SETUPS) to display the menu shown below.
FORCE
SIZE
ORG OFT
SPEED
(6) Press the [F3] key (ADJ. SENS) to display the menu shown below.
FORCE
ADJUST SENSOR
POSITION
SPEED
(7) Press the [F2] key (POSITION) to display the menu shown below.
<FC4500-50/60>
FORCE
ADJ. SENS POS
ADJ.
SPEED
(8) FC4500-50/60: Press the [F4] key (ADJ.+) to adjust the sensors. The prompt shown below is displayed.
FC4510-60: Press the [F2] key (X+) to adjust the X-axis sensor, and the [F4] key (Y+) to adjust the Y-axis sensor.
The prompt shown below is displayed.
FORCE
CHANGE TOOL
PRESS ENTER KEY!
SPEED
(9) Mount a plotting pen in tool holder 1.
(10) Press the
[CONDITION] key to display a condition settings screen, and then use the [F1] to [F4] keys to select
a COND No. where "PEN" has been selected as the cutter blade type.
(11) Use the [
] [
the position where you want to plot the cross symbol and then press the
symbol, and then the prompt shown below is displayed.
FORCE
CHANGE TOOL
PRESS ENTER KEY!
SPEED
(12) Replace the plotting pen with a cutter pen.
(13) Press the
[CONDITION] key to display a condition settings screen, and then use the [F1] to [F4] keys to select
a COND No. where a cutter blade has been selected as the cutter blade type. Press the
sensor reads the plotted cross symbol, and then cuts a second cross symbol. After the second cross symbol has
been cut, the screen shown below is displayed.
FORCE
SENSOR OFFSET ADJUST
X= 0.0 mm
SPEED
4-14
OFFSET
DIST ADJ
OTHER SETUPS
QUALITY
OFFSET
ADJ. SENS
SENS OPT
QUALITY
OFFSET
LEVEL
QUALITY
OFFSET
ADJ.+
QUALITY
OFFSET
QUALITY
] [
] [
] keys to move the pen carriage (the tip of the tool selected by the current setting) to
OFFSET
QUALITY
OFFSET
Y= 0.0 mm
QUALITY
<FC4510-60>
FORCE
X ADJ. SENS. POS Y
X+
SPEED
[ENTER] key. The plotter plots a cross
OFFSET
Y+
QUALITY
[ENTER] key. The

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fc4510

Table of Contents