Table of Contents
Advertisement
(6) Press the [F2] key (OVERLAY) to display the overlay settings screen.
FORCE
COND No.
OVERLAY
SPEED
Blinking cursor
The upper row of the display represents the cutting condition COND Nos. The lower row of the display indicates the
number of overlay operations that has been specified for each COND No.
Use the [
] or [
] key to move the blinking cursor to the COND. No. for which you want to specify the Overlay
function, and the [
] or [
Setting range: - (Off), 2 to 9 (times)
Press the
[ENTER] key to confirm your selection.
(7) When the
[ENTER] key is pressed, the screen for setting the COND Nos. for one overlay cutting operation only
is displayed.
FORCE
COND No.
FIRST No. -2-4-67-
SPEED
Blinking cursor
The upper row of the display represents the cutting condition COND Nos. The lower row of the display indicates the
COND Nos. for which overlay cutting has been specified.
Use the [
] or [
] key to move the blinking cursor to the COND. No. to which you wish to assign the first overlay
cutting operation only, and the [
Setting range: - (Off), 1 to 8 (each COND No.) (On)
[Example]
Specify overlay cutting for COND No. 1 and COND No. 2. Specify the usual FORCE value for COND. No. 1, and
then specify a FORCE value that is lower than the COND No. 1 value for COND No. 2.
FORCE
COND No.
FIRST No. 22------
SPEED
If COND No. 1 is selected to perform cutting in this status, the first cutting operation will be performed at the low
FORCE value specified for COND No.2, and the second and subsequent cutting operations will be performed at
the usual FORCE value specified for COND No. 1.
Press the
[ENTER] key to confirm your selections.
(8) Press the
[PAUSE] key to cancel PAUSE mode.
•
These settings are retained in the plotter's internal memory even while the plotter is turned off.
•
If the AUTO mode has been selected and there are no data delimiter commands (such as F0 or PG), the plotter waits
for a timeout (approx. 10 seconds) and then starts the second cutting operation.
•
Once the overlay cutting operation has started, operations such as changing the COND No., making Pause menu
settings and setting the origin cannot be performed until approximately 10 seconds have elapsed after all the cutting
operations have been completed. (The following screen appears if any of these keys are pressed during the overlay
cutting operation.)
FORCE
PREPARING TO RECUT
SPEED
OFFSET
12345678
-9-7-6-4
QUALITY
] key to select the number of overlay operations.
OFFSET
12345678
QUALITY
] or [
] key to make your selection.
OFFSET
12345678
QUALITY
OFFSET
QUALITY
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5-9
Advertisement
Table of Contents
