GRAPHTEC FC4500 User Manual page 5

Safety Precautions
When disconnecting the power cord or an interface
cable, do not pull on the cord/cable.
•
Such action will damage the cord/cable, resulting in a fire
hazard or electrical shock. Be sure to hold the power cord's
plug or the interface cable's connector.
Prohibited
Do not clean the plotter using a volatile solvent (such
as thinner or benzine).
•
Such action may impair its performance.
Prohibited
Provide sufficient space around the plotter so that
the media does not strike any objects in the plotter'
s vicinity during cutting or plotting.
•
Such contact may cause cutting or plotting to go out of
alignment.
No touching
When using the cutter pen, take care not to extend
the cutter blade excessively.
•
An excessive blade length will damage the cutting mat and
impair the plotter's cutting quality.
iv
Safety Precautions
Do not place magnetic cards, diskettes or similar in
the vicinity of the tool carriage.
•
The magnetic force may destroy the data on the magnetic
cards or diskettes.
Do not attempt to lubricate the plotter's
mechanisms.
•
Such action may cause it to break down.
If water or foreign matter enters inside the plotter,
do not continue using it. Turn off its power and
unplug its power cord from the electrical socket.
•
Use of the plotter in such status may result in electrical shock
or a fire hazard due to current leakage.
•
Contact your sales representative or nearest Graphtec vendor
to request repair.
Unplug the power
cord from the socket
Move the tool carriage slowly when moving it
manually in order to load the medium or for other
reasons.
•
Moving it quickly may damage the plotter.
Prohibited
Prohibited