Setting The Registration Mark Spacing; (Fc4510-60 Only); Setting The Center Registration Mark (Fc4510-60 Only) - GRAPHTEC FC4500 User Manual

Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
An example of the MIRROR setting
FORCE
•1 MARK TYPE
2
SPEED
When the displayed setting is satisfactory, press the

Setting the Registration Mark Spacing

(1) If registration mark 3 has been selected, the menu for setting the registration mark pattern spacing is displayed.
FORCE
MARK TYPE:3
SPACING =
SPEED
Use the [ ] or [
[ENTER] key to confirm your selection.
Setting range: 0 to 9.9 (mm) [Default value: 3]
Registration mark pattern 3
Set value
Setting the Center Registration Mark
The center registration mark can only be read when three-point reading has been selected for the registration mark
mode, and when "3" has been selected for MARK TYPE and "USER" for the registration mark distance adjustment
function.
(1) When registration mark pattern 3 has been selected and the
center registration mark is displayed.
FORCE
CENTER
X=----.-mm Y=---.-mm
SPEED
(2) To perform plotting with the center registration mark as the reference point, press the [F1] key (CENTER) to affix the
•
black dot [ ] next to CENTER and display the following menu. If you do not wish to perform plotting with the center
registration mark as the reference point, press the [F1] key once again to remove the black dot [
the [ENTER] key.
FORCE
•CENTER
X=0030.0mm Y=030.0mm
SPEED
To perform plotting with the center registration mark as the reference point, press the [F2], [F3] or [F4] key to
move the blinking cursor to X (X-axis length), W (center registration mark reading position) or Y (Y-axis length)
respectively. Use the [
and the [ENTER] key to confirm your selections.
4-6
OFFSET
3
MIRROR•
QUALITY
OFFSET
3.0 mm
QUALITY
] key to change the numeric value. When the displayed setting is satisfactory, press the
OFFSET
W= --.-mm
QUALITY
OFFSET
W= 00.0mm
QUALITY
] or [ ] key to move the blinking cursor, the [
[ENTER] key to confirm your selection.

(FC4510-60 only)

(FC4510-60 only)
[ENTER] key pressed, the menu for setting the
] or [
•
] and then press
] key to change the numeric value