GRAPHTEC FC4500 User Manual page 21

...........................[ENTER] key
After setting a function or condition at the control panel, press the [ENTER] key to register your
setting.
To reset the plotter, concurrently press the [ENTER] and [ORIGIN] keys. (Key reset function)
...........................[ORIGIN] key
Used to move the origin point.
Press this key to initiate the respective function when "MARKS" or "AXIS" has been selected
for the registration mark mode.
To reset the plotter, concurrently press the [ENTER] and [ORIGIN] keys. (Key reset function)
...........................[COPY] key
Used to output a copy of the data in the plotter's receive buffer.
...........................[CONDITIONS] key
Used to change the currently displayed cutting conditions.
...........................[TEST] key
Runs a cutting test to check whether the currently selected cutting conditions are compatible
with the medium loaded.
...........................[NEXT] key
Used to select the desired menu screen for setting a function at the control panel when the
plotter is in PAUSE mode.
...........................[STOP/VIEW] key
During a cutting/plotting/creasing operation, press this key to immediately stop cutting/plotting/
creasing. While the Ready message is being shown on the plotter's display panel, press this
key to move the tool carriage to the outer limit of the maximum cutting/plotting area. To return
the tool carriage to its original position, press this key once again.
Chapter 1 PRODUCT SUMMARY
1-5