Replacing The Main Power Supply - Christie HS 2K Series Service Manual

16. Unplug the main power supply to DC 12 power supply harness connector.
17. Flip the shielding cover on the left of the power supply.
18. Remove the two M3 screws with a Phillips #1 screwdriver and lift the mylar cover.
19. Unplug the three connectors.
20. Remove the two M3 screws with a Phillips #1 screwdriver.
21. Replace the DC 12V power supply.
22. To re-install, follow these steps in reverse order.

Replacing the main power supply

The main power supply provide the power to laser bank and laser driver.
1. Remove the top cover.
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
To fan 8
To main board fan 8
To main board
Electronics
76