Table of Contents
Advertisement
HW INSTALLATION
4.3.3. Power Supply
Connect the supplied power supply to the Compute Box 24V connector.
Quick Changer
1.5 A
5 A
Finally, power up the power supply that will power the Compute Box and the connected
Tool(s).
3FG15
HEX-E/H QC
RG2/6 RG2-FT
Screwdriver
NOTE:
To disconnect the power connector,
make sure to pull the connector housing
(where the arrows are shown) and not
the cable.
CAUTION:
Use only original OnRobot power
supplies.
VG10/VGC10
31
Advertisement
Table of Contents
Need help?
Do you have a question about the HEX-E QC and is the answer not in the manual?
Questions and answers