Table of Contents
Advertisement
SW INSTALLATION
NOTE:
If the Tool connector option is selected in the Device info drop-down menu but
no OnRobot product is connected to the tool connector then a background
service program is running every 2 seconds. In addition to that the Tool IO is
set to be logic high and low randomly.
CAUTION:
After any error message is shown that is related to the connection to our
devices, please go to the Device info to make sure that the right settings (e.g.:
TCP) are used.
To get more information about the devices press on
38
and the following screen will show:
Advertisement
Table of Contents
Need help?
Do you have a question about the HEX-E QC and is the answer not in the manual?
Questions and answers