OnRobot HEX-E QC User Manual page 87

OPERATION
Generate warning when insertion unsuccessful: If enabled, a pop-up message (blocking)
appears if the insertion was not successful.
NOTE:
The option is only active when a valid limit has been set at the advanced
screen.
If disabled, then no pop-up message is shown but the user can handle any possible errors by
the return value of the command.
See return values in the
F/T Control
Applications such as polishing, deburring, sanding or grinding may require holding constant
force/torque to a defined direction during movements.
This command alters the trajectory of its child node(s) in order to keep the force/torque values
constant along/about the selected axes.
NOTE:
UR's built-in Move commands cannot be used under the
command. To move the robot under the force control, use the
F/T Search
NOTE:
To cancel any force/torque offset, execute an
beginning of the
contact with any object before starting the
command may not work properly.
6.5. Return Values section.
command instead.
F/T Control
F/T Zero
command and make sure the tool is not in
F/T Control
F/T Control
or
F/T Move
command at the
, otherwise the
87