Table of Contents
Advertisement
3-2
Installation
Removing Melter
Disposing of Melter
Installation Requirements
Exhausting Material Vapors
Fig. 3-2
P/N 7146386A
Run the melter until empty, separate all connections from the melter, and
allow the melter to cool down.
When your Nordson product has exhausted its purpose, dispose of it
properly according to local regulations.
Set up only in an environment that corresponds to the stated Degree of
Protection (Refer to section Technical Data). Do not set up in a potentially
explosive atmosphere! Protect from vibration.
CAUTION: Protect the control panel from direct sunlight. The UV rays
reduce the service life of the liquid crystals.
Ensure that material vapors do not exceed the prescribed limits. Always
observe the safety data sheet (MSDS) for the material to be processed. If
necessary, exhaust material vapors and provide sufficient ventilation of the
location of the system.
VBN w/o Control System
E 2008 Nordson Corporation
Advertisement
Table of Contents
Troubleshooting
