Dip Switch; Figure 27: Dip Switch (For Example Setting "0") - WAGO -I/O-SYSTEM 750 Manual

52 Device Description
Pos : 39.1 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/DIP-Sc halter - Übersc hrift 3 @ 15\mod_1369661120678_21.doc x @ 120594 @ 3 @ 1
4.5.2

DIP Switch

Pos : 39.2 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/DIP-Sc halter-Bild ( 8 ... 1 von oben nac h unten) Bilduntersc hrift: DIP-Sc halter @ 15\mod_1369661277690_21.doc x @ 120600 @ @ 1

Figure 27: DIP Switch (for example setting "0")

Pos : 39.3 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/Adr ess wahlsc halter PR OFIN ET: D er Adr ess wahls chalter di ent z ur opt. Eins t. der Gerätenamen (375, 377) @ 13\mod_1353570866643_21.doc x @ 106753 @ @ 1
The DIP switch can be used to assign a device name to the fieldbus coupler,
which can be selected from two pre-defined character strings and can be
instantiated each. It is also possible to reset the fieldbus coupler to the factory
setting.
DIP switch settings only applied after reset!
Please note that any settings made are only applied during start-up, i.e. after
switching on the supply voltage (hardware reset) or in operation after software
reset. If one of the specified resets is not carried out, changes to the switch
settings are not applied during operation!
Pos : 39.4 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Bedienel emente/F el dbus koppl er/-contr oller/Adr ess wahlsc halterbesc hreibung - Koppl er (750- 375) @ 13\mod_1353571203918_21.doc x @ 106756 @ @ 1
750-375 PROFINET IO advanced Fieldbus Coupler
WAGO-I/O-SYSTEM 750
Manual
Version 1.1.0