Profienergy Submodules (Ao, Pe); Table 190: Parameterization Ao, 562, 563 - Attribute "Output; Table 191: Parameterization Ao, 562, 563 - Attribute "Behavior On K-Bus Timeout; Table 192: Parameterization Ao, 562, 563 - Attribute "Switch-On Delay [S] - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-375 PROFINET IO advanced Fieldbus Coupler
Table 190: Parameterization AO, 562, 563 – Attribute "Output"
Attribute Name
Output
Table 191: Parameterization AO, 562, 563 – Attribute "Behavior on K-Bus timeout"
Attribute Name
Behavior on K-Bus
timeout
Table 192: Parameterization AO, 562, 563 – Attribute "Switch-on delay [s]"
Attribute Name
Switch-on delay [s]

14.2.10 PROFIenergy Submodules (AO, PE)

When configuring PROFIenergy submodules, an additional parameter data set is
sent to the data se number or index 0x5000 or 20480.
Regarding the PROFIenergy properties, the following attributes can also be
specified during parameterization.
Table 193: Parameterization – Overview of Additional Attributes for PROFIenergy Submodules
(AO, PE)
Additional Attributes for PROFIenergy Submodules (AO, PE)
- Minimal pause time (additionally)
- Pause output value (additionally)
Manual
Version 1.1.0
Attribute Value Description
in parameterized
See corresponding manual for I/O modules
operating mode
75x-562, 750-563
www.wago.com.
high-impedance
Attribute Value Description
output 0 V
hold last output value See corresponding manual for I/O modules
75x-562, 750-563
output factory
www.wago.com.
substitute value
output user substitute
value
Attribute Value Description
0
0.10
0.20
0.30
See corresponding manual for I/O modules
75x-562, 750-563
0.50
www.wago.com.
0.75
1.00
2.00
Appendix 191