WAGO -I/O-SYSTEM 750 Manual page 61

WAGO-I/O-SYSTEM 750
750-375 PROFINET IO advanced Fieldbus Coupler
Increase total length using a WAGO internal data bus extension module!
Using an internal data bus extension module from WAGO, you can increase the
total length of the fieldbus node. In this type of configuration, you must connect a
750-627 Bus Extension End Module to the last module of the node.
You then connect the 750-627 module to the 750-628 Coupler Module of the next
I/O module assembly via RJ-45 cable.
You can connect up to 10 internal data bus extension coupler modules 750-628 to
an internal data bus extension end module 750-627. In this manner, you can
logically connect up to 10 module assemblies to a 750-375, dividing a fieldbus
node into 11 assemblies maximum.
The maximum cable length between two assemblies is 5 meters. For additional
information, refer to the 2750-627/-628 Modules2 manual. The total cable length
for a fieldbus node is 70 meters.
Pos : 57.3 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Mounting 61